Home

(HQ) The Car Radiator. De autoradiator. How is it made? ...

A radiator is a type of heat exchanger. It is designed to transfer heat from the hot coolant that flows through it to the air blown through it by ...

fast mini 1430cc 0-60

Now 1430cc A-series with 136bhp. Weber 45 DCOE Carburettor on Longman 5.5in Alloy Inlet Manifold polished and matched to the head. Pipercross Air ...

MKV-DHC 2009/03/03

missing or connected wrong, the carbs needed rebuilding, then I pulled the fuel tank, the radiator (that was recored) waterpump needed new ...

1947 Chevrolet 3100 Pickup

Vintage A/C system, new fuel lines, fuel pump, poly fuel tank with stainless fuel inlet, Afco aluminum radiator with electric fan, new exhaust ...

Solar water heating system on the roof

For the battery capacity of 32 is taken of any configuration, the volume of 300-900 liters, and is installed on the sunny side of the roof of a house or extension, or on an ad hoc support.

The bottom of the container should be at 200-500 mm above the distributor cap 4 of the boiler system (see Fig. 10).

Pipelines from the battery summed up in the bathroom, the kitchen and connected to the water-networks of hot water so as to be able to use water from the solar battery 32 and the distributor of the 4 boilers, so that they do not interfere with each other in operation.

This requires riser (0-20 mm) with one end attached to a water line 8 and the second end of the pipe riser attached to the bottom of the battery 32. Scheme of hot water from solar panels

From the battery to the opposite tube (0-15-20mm), one end of which is attached on top, under the battery cover 32 and lower end attached to a mixer bath 33, via jumper “P” and fork to the sink in the kitchen “P”.

This simple connection gives the possibility to use hot water from the battery 32 and the distributor 4.

To do this, open the valve from 8 cold water on the standpipe rises and fills the battery 32. Sun-heated water in the radiator to return pipe goes down to a mixer 33, via jumper “P” and go on like in the shower and the kitchen sink in the “P”.

Here it is necessary to explain that getting hot water from solar panel 32 is way of squeezing, ie, the valve is opened from 8 water supply system, cold water pressure raises your hot water from the battery 32 and it comes through the back line in the parsing of hot water piping 9 through jumper “P”.

In some cases, you can get hot water and a way to drift. To do this, on the back of the line to open the air vent 37a and open the valve on the dam “P”. Air valve 37a is installed under the ceiling, above the tube, inlet hot water in the shower, and tube 9, serves hot water from the distributor 4. Otherwise, water will overflow from the valve on the discharge. In the proposed method of water going into the mixer, shower, bathroom and the kitchen at the opening of the valve “P”. Taco Circulator Pumps & Flanges for PEX Tubing.

Read more...